EK-FC R9-280X DCII (Original CSQ) - Nickel
This water block directly cools the GPU, RAM as well as VRM (voltage regulation module) as water flows directly over these critical areas thus allowing the graphics card and it's VRM to remain stable under high overclocks. EK-FC R9-280X DCII water block also features a very high flow design therefore it can be easily used in liquid cooling systems using weaker water pumps. The cooling engine now uses refined, 0.6mm wide microchannel structure to even further improve the heat transfer.
Features Base is made of nickel plated electrolytic copper while the top is made of quality cast satin finish acrylic material. The sealing is performed by quality rubber washers. Screw-in brass standoffs are pre-installed and allow for safe, painless installation procedure. Block is mounted with enclosed M3x4 DIN7985 screws.
EKWB recommends the purchase of aesthetic retention backplate (EK-FC R9-280X DCII Backplate - Black) which improves the looks of your graphics cards and also provide some passive cooling to the VRM section.
Flow orientation doesn't matter and is thus not prescribed.
Up to four EK-FC R9-280X DCII series water blocks can be interconnected with EK-FC Bridge & Link CSQ system. The EK-FC Link is already enclosed.
- EK-FC R9-280X DCII series water block
- EK-FC Link
- mounting mechanism with screw-in brass standoffs
- thermal pads
- thermal grease EK-TIM Ectotherm (1g)
|Chipset Compatibility||Radeon R9 280X|
|Base Material||Copper/ Nickel Plated|
Please note your statutory rights are not affected.
For further information regarding Scan's warranty procedure please see our terms and conditions
Warranty information has not yet been updated for this product. For further information please call 0871 472 4747 or 01204 474747.